#Motion sensor flood lights factory series#

The floodlight will be turned on when the PIR motion detector sensor the human or any motion, and it will be turned off if there is no human being or any. Through the perfect combination of conventional floodlights and PIR motion sensors. Motion Sensors: Motion sensors are a common feature in LED flood lights, and they help to enhance their energy efficiency by turning the lights on when movement.

#Motion sensor flood lights factory series#

GR-FL-I series is our PIR motion sensor floodlights. When the LED stops blinking, your Listener* has reset. PIR Motion Sensor floodlights 10W-50W Model: GR-FL-I. Press and hold the Setup button for about 10 seconds. Press and hold the Connect Button (located on the side of the device) for 10 seconds until the LED Ring blinks once, then release the button. Press and hold the setup button (located on the side of the device) with the battery in, until the LED stops flashing (approximately 10 seconds) Press and hold the setup button (located inside the device) with the battery in, until the LED stops flashing (approximately 10 seconds). NOTE: The device will not remain awake after resetting and will go into standby mode. If the device is powered up with the test button held down for 10+ seconds, the device will reset all Z-Wave settings and leave the network. Please contact Customer Support for assistance if you're having difficulty with your Ring Alarm.įactory Reset your First Alert Smoke & CO Detector

Range Extender (1st generation) and (2nd generation)ĭo not attempt to factory reset your Ring Alarm Base Station without guidance and support from a trained Ring Customer Support expert. If you ever get stuck while troubleshooting your Ring Alarm devices and need to factory reset any of them (as a last resort), you can use the instructions below: